Mole-Richardson One-Light Molepar (Type 2271)

Last Updated 3 hours ago

Overview

One-Light Molepar Type 2271 with its front safety screen and tilt yoke

The One-Light Molepar puts a single PAR64 lamp in a short housing with a ⅝ in. stand receiver. The lamp sets the beam spread. Rotating the housing turns the oval on its axis, while an optional front intensifier concentrates the beam. At 15 ft, Mole-Richardson lists 560 fc for the bare FFN very narrow spot and 900 fc with the Type 2275 specular intensifier.

Key specifications

SpecificationDetails
Maximum rating1,000 W, 120/240 V AC or DC, 8.3 A maximum as marked
SocketExtended mogul end-prong PAR64
Cable and switch25 ft three-conductor lead with inline switch
Body9¼ in. diameter × 7¾ in. long
Weight7¾ lb with cable
MountCast-aluminum yoke, ⅝ in. stand or hanger spud

Replacement lamps

These are the six 1,000 W, 120 V PAR64 lamps listed by Mole-Richardson. The manufacturer also lists 500 W, 2,800 K alternatives in narrow, medium and wide spreads.

Lamp codeBeamColourRated life
FFNVery narrow spot3,200 K800 h
FFPNarrow spot3,200 K800 h
FFRMedium flood3,200 K800 h
FFSWide flood3,200 K800 h
FGMNarrow spotDichroic daylight200 h
FGNMedium floodDichroic daylight200 h

Look up replacement lamp codes for this fixture.

Strengths and limitations

  • The optional intensifier can increase centre output without changing the lamp. On the 15 ft chart, the medium flood goes from 150 fc bare to 225 fc with the diffuse intensifier.
  • The PAR lens fixes the basic spread. Rotating the head reorients the oval. A change from a spot to a flood requires a different globe.

Practical uses

For a narrow shaft of light through a window, set the long axis of the oval first. At 15 ft the FFN pattern measures 6.4 × 3.7 ft bare and 4.4 × 3.0 ft with the 2275. If the window is the same width as the bare beam, fitting the intensifier may cut off the edges even though the centre gets brighter.

Output and photometrics

Mole-Richardson’s performance heading says 650 W, while its globe table rates the same six lamp codes at 1,000 W. The test wattage is unresolved. The figures below reproduce the published values by lamp code and intensifier. Use a meter to confirm the level from the lamp in hand.

Configuration (fc at centre)5 ft10 ft15 ft20 ft30 ft40 ft50 ft
FFN very narrow spot · bare5,0401,2605603152009050
FFN very narrow spot · 2275 specular8,1002,03090051032015080
FFP narrow spot · bare3,6009004002251456535
FFP narrow spot · 2275 specular6,3001,57570039025011060
FFR medium flood · bare1,350340150855525No data
FFR medium flood · 2276 diffuse2,0255102251308035No data
FFS wide flood · bare470120523020No dataNo data
FFS wide flood · 2276 diffuse9402401056040No dataNo data
FGM narrow spot · bare2,7006753001701105025
FGM narrow spot · 2275 specular4,7251,1805253001909045
FGN medium flood · bare900225100553515No data
FGN medium flood · 2276 diffuse1,350335150805020No data

Manufacturer’s original output and beam dimensions (PDF).

Photometric & exposure calculator

Estimate centre-beam illumination and the corresponding camera aperture from this fixture’s published measurements.

Estimated output

Illuminance—lux
Foot-candles—fc
Approximate f-stop—nearest 1/3 stop

Select a configuration to calculate.

Manufacturer readings are for the stated optic, colour setting and full output, measured at the beam centre. Values between measured distances are interpolated. Point-source values outside those distances are approximate inverse-square estimates; large sources cannot be reliably extrapolated and are limited to their measured range. Exposure uses frame rate, shutter angle, ISO and the selected incident-meter calibration. Only the optics and diffusion explicitly listed in the measurement are included; additional modifiers, bounce, beam edges, ambient light, ND filters and camera exposure-index differences are not accounted for. Confirm critical exposures on set with a meter.

Power and controls

The manufacturer specifies a 25 ft lead with an inline switch and lists the plug as an ordering choice. The head accepts lamp versions for different supply voltages. Check the voltage on the actual globe before connecting the head.

Optics and mounting

Mole recommends the Type 2275 specular intensifier for the very narrow and narrow spots, and the Type 2276 diffuse intensifier for the medium and wide floods. The head also accepts 10⅛ in. scrims, the Type 41252A four-leaf barndoor and the Type 22761 Parsnoot.

Comparable fixture

For a larger area, the Six-Light Molepar (Type 5761) takes six 1 kW PAR64 lamps in pivoting pairs. Use the six-light chart for that configuration.

Field coverage and further reading

Renovo Rentals identifies its single PAR as Type 2271 and gives the 15 ft figure for an FFN lamp with the 2275. Ask for that accessory by number if the shot depends on its tighter beam. Renovo Rentals Type 2271 listing.

Rental and used-fixture checks

Check the lamp code, front safety screen and accessory clips. An order for a PAR64 head alone leaves the lamp spread and the intensifier unspecified. Confirm the intensifier type and the power plug with the supplier.

Documentation

Back to contents · Browse all lighting equipment