Godox KNOWLED GF14 Fresnel Lens

Last Updated 1 day ago

Godox GF14 Fresnel attachment

The GF14 puts a 14-inch focusing Fresnel in front of a compatible KNOWLED G-mount light. On a window push, spotting the lamp buys level at the centre of the opening. Flooding it can make better use of a wide window or a bounce that needs even coverage from corner to corner.

Model
GF14
Mount
Godox G
Beam range
15° to 45°

Compatible fixtures

Godox lists the GF14 for the MG1200Bi/R and MG2400Bi/R families. Check the version on the rental shelf. Earlier GF14 packages were sold for the MG1200Bi alone, while the updated lens is listed for both bi-colour heads. The MG6K manual specifies an upgraded temperature-resistant mount for its GF14 pairing. A G-mount label on its own does not identify that upgrade.

Key specifications

SpecificationDetails
Front optic14-inch Fresnel
Spot to flood15° to 45°
Rear interfaceGodox G mount
Barn doorsGF14B, ordered separately
Version checkMatch the lens revision and approved fixture on the rental order

MG1200Bi output at 5,600 K

Godox measured the MG1200Bi at full brightness with the GF14. At 3 m the spot centre reads about 4.2 times the flood centre. That difference is useful for a long throw, but it comes with a narrower illuminated area. Use the measurements for this specific head.

DistanceGF14 spotGF14 flood
3 m86,100 lux20,600 lux
5 m30,100 lux7,910 lux
7 m15,300 lux4,510 lux
9 m9,180 lux2,750 lux

Practical uses

For a daylight bounce through a window, set the lens near flood and look at the corners of the bounce from the lamp position. Tighten the beam only until the usable surface is filled. For a direct shaft, set focus for the required width first, then use the optional GF14B doors to keep the same beam off the ceiling.

Rental and used-gear checks

  • Confirm the GF14 revision against the exact head, especially when substituting an MG2400-series fixture for an MG1200Bi.
  • Ask for GF14B explicitly if the shoot needs doors. Match them to the Fresnel at prep.
  • Run the full focus travel on the booked head. Record the distance, CCT and spot or flood position alongside the meter reading.

Back to contents