ARRI Orbiter Fresnel Lens 15–65°

Last Updated 10 hours ago

ARRI Orbiter Fresnel Lens 15–65°

The Orbiter Fresnel is a motorized 15° to 65° optic for the ARRI Orbiter. A board operator can widen the pool between cues while the lamp stays in place. That makes it a practical rental for a high window position, a studio grid or a stage where access to the head is limited.

ARRI part number
L2.0039436
Motorized zoom
15° to 65°
Minimum firmware
LiOS 2.0

Compatible fixtures

The lens attaches to the Orbiter Quick Lighting Mount (QLM). ARRI specifies LiOS 2.0 as the minimum fixture software. The lens has a local angle display. The crew can set zoom from the Orbiter control panel or through a compatible DMX or network control setup.

Key specifications

SpecificationDetails
ARRI part numberL2.0039436
Front lens diameter285 mm (11.2 in)
Optic weightApproximately 4.5 kg before doors
HousingApproximately 340 × 380 × 370 mm
Optional doorsFour-leaf L2.40950.0 or eight-leaf L2.40960.0

Fresnel or fixed Open Face optic?

Choose the Fresnel when the spread changes during the day or a smooth transition from centre to edge matters. For a narrow, fixed throw, the dedicated 15° Open Face optic has an output advantage. Both fit the Orbiter, so it pays to put the actual optic on the order.

At 5,600 K, 1 m, High CRI modeMotorized FresnelFixed Open Face optic
15°56,400 lux85,400 lux
30°25,800 lux47,600 lux

Independent testing

Matthew Allard measured both configurations for Newsshooter with the same Orbiter and meter. The fixed optics gave a brighter centre at both angles. His wall shots and off-axis readings also show how the Fresnel falls away toward the edges, which matters when an actor crosses the pool. Read the full test at Newsshooter.

Practical uses

For a cue that opens from one performer to two, set and record the start and end angles, then run the move at show speed. Watch both performers and the background during the transition. Widening the beam also lowers the centre level, so the cue may need a corresponding intensity change.

Rental and used-gear checks

  • Confirm the head software, the requested barn-door set and the control profile during prep.
  • Run a zoom from the console that will operate the lamp and check clearance at the fixture’s steepest tilt with the doors open.

Video

ARRI Tech Talk on the Orbiter Fresnel

Back to contents