Last Updated 5 hours ago
Overview
The original daylight Evoke 1200 is a large COB head with interchangeable NL-mount optics. It works as a hard window source or a distant bounce. Nanlux also documented a separate fixed-tungsten version of this model.
- Type
Fixed-daylight COB LED spotlight with interchangeable NL optics. - Power
1,200 W rated head; separate 100–240 V AC power supply. - Colour Temperature5600 KThis daylight version is fixed; the 3200 K model is a separate fixture.
- Weight / Mount
6.94 kg head, 1.84 kg yoke and 10.5 kg power supply. NL optic mount. - Beam Control
Interchangeable 26°, 45° and 60° reflectors, compatible Fresnel and soft modifiers. - IP RatingIP54 Dust-protected and splash-resistant in the specified configuration. See the IP Rating Guide.
Key specifications
| Specification | Details |
|---|---|
| Manufacturer and model | Nanlux Evoke 1200 |
| Source or rated power | 1,200 W rated head |
| Optics, colour or format | 5,600 K daylight version |
| Head or system detail | NL mount, separate supply |
Photometric Output Calculator
Estimate centre-beam illumination and the corresponding camera aperture from this fixture’s published measurements.
Estimated output
Select a configuration to calculate.
Manufacturer readings are for the stated optic, colour setting and full output, measured at the beam centre. Values between measured distances are interpolated. Point-source values outside those distances are approximate inverse-square estimates; large sources cannot be reliably extrapolated and are limited to their measured range. Exposure uses frame rate, shutter angle, ISO and the selected incident-meter calibration. Only the optics and diffusion explicitly listed in the measurement are included; additional modifiers, bounce, beam edges, ambient light, ND filters and camera exposure-index differences are not accounted for. Confirm critical exposures on set with a meter. Photometric source
Model and Family Fit
This is the fixed-daylight Evoke 1200. Compare the 1200B separately when variable white is required; neither the output charts nor optic results are interchangeable.
Strengths and limitations
- The optical family gives several measured beam widths for a single high-output daylight head.
- This head is fixed at 5,600 K. To match a 3,200 K tungsten setup, use CTO gel in a suitable holder to warm the beam. Check the result on camera and re-meter for the light the gel absorbs.
Working with the Evoke 1200
Compare the bare head with the 26° and 45° reflectors at the actual throw. A higher centre reading from a tighter reflector can leave the corners of a large frame underfilled.
Output and photometrics
| Configuration | Distance | Lux | Foot-candles (converted) |
|---|---|---|---|
| 5,600 K · bare | 3 m | 5,532 | 514 |
| 5,600 K · bare | 5 m | 2,373 | 220 |
| 5,600 K · bare | 7 m | 1,266 | 117.6 |
| 5,600 K · bare | 10 m | 679 | 63.1 |
| 5,600 K · 26° reflector | 3 m | 58,050 | 5,393 |
| 5,600 K · 26° reflector | 5 m | 18,370 | 1,707 |
| 5,600 K · 26° reflector | 7 m | 9,180 | 853 |
| 5,600 K · 26° reflector | 10 m | 4,626 | 430 |
| 5,600 K · 45° reflector | 3 m | 18,460 | 1,715 |
| 5,600 K · 45° reflector | 5 m | 6,583 | 612 |
| 5,600 K · 45° reflector | 7 m | 3,671 | 341 |
| 5,600 K · 45° reflector | 10 m | 2,021 | 187.8 |
Photometric source and test conditions.
Independent Measurements
Newsshooter’s daylight unit measured 14,100 lux at 3 m with the F-35 Fresnel at 45°. Its 11° test showed a pronounced centre hotspot and materially different readings depending on where the meter was placed; the field was flatter at 45°. Use the manufacturer chart in the calculator, and check both centre and edge in prep when that beam is doing critical work. Newsshooter’s independent measurements.
Power and controls
A separate supply feeds the head at up to 48 V DC and 25 A. The original daylight model supports DMX/RDM and wireless control.
Control and Camera Operation
Confirm the planned control mode and run the light through a cue with the selected fan mode. Make the sound and on-camera checks with the head in its working position.
Optics and mounting
The NL mount accepts reflectors and the optional Fresnel. The 26°, 45° and 60° reflectors throw different fields even at the same dimmer setting.
Choosing the Optic or Modifier
Choose the narrower or wider NL reflector by coverage at the planned distance. If considering the F-35, check the beam centre and door gaps at the actual setting rather than assuming a uniform field.
Comparable fixtures
For the bi-colour Evoke in this power class, see Nanlux Evoke 1200B. For a higher-output bi-colour alternative, compare the Evoke 2400B and account for the larger power requirement.
What People Are Saying
Field Feedback at a Glance
What worked
- The daylight head had enough output to serve as a high-power source on mains in Allard’s test. Matthew Allard ACS, Newsshooter.
- He found the tint relatively neutral, even though the measured color temperature didn’t always match the label. Matthew Allard ACS, Newsshooter.
- Sheldon liked the native modifier selection: a tight reflector or the FL-35 Fresnel gave him a way to shape the beam in bright sun. Graham Sheldon, CineD.
Drawbacks to plan for
- Allard found the fan audible enough to factor it into sound-sensitive setups. Matthew Allard ACS, Newsshooter.
- The head becomes awkward to mount with the large FL-35 Fresnel attached. Matthew Allard ACS, Newsshooter.
- Sheldon wanted the option to dial in a warmer color temperature. This original daylight head is fixed, unlike the 1200B. Graham Sheldon, CineD.
Matthew Allard ACS, Newsshooter
Allard saw spill through the Fresnel barn-door gaps. Check for stray light with the actual optic if you need a clean cut.
Field coverage and further reading
Video
Gaffer & Gear 173 – Nanlux Evoke 1200
Rental and used-fixture checks
Confirm daylight on the label, check the head cable and lens mount, and test the selected control and fan mode. The 1200B uses a different output chart.
Before You Book
Confirm the daylight model, power supply and head cable, then test the actual reflector or Fresnel with any doors in the rental package.
Documentation
Back to contents · Browse Nanlux lights · Browse all lighting equipment
