Rosco DMG MINI MIX

Last Updated 15 hours ago

Rosco DMG MINI MIX Overview

MINI MIX panel
External MIX control unit
MIX controllerThe external MIX control unit keeps the fixture’s controls accessible.
Rosco DMG MINI MIX AC kit with panel, driver, power supply, offset mount and cable
AC kitDMG MINI MIX with the offset mount and 2 m cable. Photo: Rosco.

The MINI MIX is Rosco’s narrow soft panel with red, green, blue, lime, amber and white emitters.

The slim head can go beside a window, over a desk or into a vehicle while the controls stay within reach.

Detail photo

  • Type
    Six-colour MIX-engine soft LED panel
  • Power
    100 W maximum; requires a separate driver and power supply.
  • Colour Temperature1,700–10,000 K
  • Weight 2.56 kg head only; separate driver and power supply.
  • Beam Control
    Optional doors, diffusion and dome change coverage and output.
  • IP Rating
    No numeric rating listed in the manufacturer’s datasheet.

Jump to Output Calculator ↓

Key Specifications

SpecificationDetails
Manufacturer and modelRosco DMG MINI MIX
Manufacturer product number298223000201 in Rosco’s preliminary DMG MINI sheet
Source or rated power100 W six-colour LED softlight
Optics, colour or format1,700 to 10,000 K
Head or system detail2.56 kg head, separate driver and power supply
Emitter mixRed, lime, green, blue, amber and 4000 K white; red, lime and amber are phosphor-converted
Housing and circuit boardAluminum

Output Calculator

Select the published setup and a manufacturer distance, or enter a custom throw where supported. The results describe centre-beam output, not the brightness across the whole beam.

Camera Settings

If the calculator does not load, use the published photometric table or source on this page. JavaScript is required.

F-stop is a planning estimate, not a meter reading. It uses direct, on-axis illuminance and includes only the optics and diffusion named in the selected setup. Meter on set to account for lens transmission, filters, added diffusion, bounce, dimming and ambient light.

How the exposure estimate works

N = √(E × ISO × t / C), where E is illuminance in lux and t = shutter angle ÷ (360 × fps). The default C = 340 is a dome reference; C = 250 is a flat reference. These are calibration constants, not a measured T-stop. A small nonzero digit is tenths of a stop above the displayed full stop.

Distance estimates and comparisons

Published points are used as given. Between published points the calculator fits a curve through the two nearest readings. Outside those points it uses the inverse-square law only when the fixture’s dataset permits it. Distances outside a configuration’s supported range are reported separately. Comparisons use one shared distance and camera setup; equal lux does not imply equal coverage.

Strengths and Limitations

  • A narrow profile and six-colour mix suit a close vehicle or desk setup.
  • Its separate controller and supply add cable management when the head is hidden.

Practical Uses

Use gel mode to explore a named colour, then assess it on the actual wardrobe. For a soft daylight key compare diffusion options against Rosco’s published readings for the uncovered panel.

Output and Colour

ConfigurationDistanceLuxFoot-candles
5,600 K · without diffuser1 m2,260210
5,600 K · without diffuser3 m26624.7
3,200 K · without diffuser1 m2,100195.1
3,200 K · without diffuser3 m25023.2

Photometric source and test conditions.

Rosco’s linked preliminary sheet supplies only these four readings, all without a diffuser. The calculator remains within 1–3 m; intermediate values are estimates. Neither the diffuser, dome nor colored-gel modes have separate measured curves in this source.

On-set check

Rosco’s four chart values are for the uncovered panel. Before basing an exposure on them, meter the exact front fitted for the shot and check the edge of its spread. A Snapbag or grid changes the distribution as well as the centre reading.

Independent Measurements

In the 2018 Definition review, Phil Rhodes metered approximately 2,470 lux at 3,200 K and 2,210 lux at 5,600 K from 1 m. These are his readings, not Rosco’s calculator inputs.

Power and Batteries

The MINI MIX needs its external MIX controller plus either the separate 100–240 V AC power supply or the appropriate battery adapter. Rosco lists 12–35 V DC for the MINI MIX. Confirm the driver, power source and cable are in the rental kit; the bare panel cannot run on its own. See the Rosco MINI/SL1 MIX manual.

Control, Cooling and Camera Operation

Control the fixture from the MIX controller, pair a phone with myMIX over Bluetooth, or connect it to a console. Rosco lists wired DMX/RDM, CRMX and Art-Net; confirm which connections the supplied controller supports before the light goes out of reach.

Choose White for colour temperature, Gel for Rosco gel presets, Color for HSI or XY with Rec. 709/2020 overlays, and Effects or Source Match when needed. Those modes are not separate measured calculator configurations. Rosco’s preliminary sheet lists flicker-free operation up to 4,000 fps; test your actual frame rate, shutter and dimmer settings before a high-speed take.

Modifiers, Rigging and the Working Package

Doors, diffusion and a dome change the panel’s spread and forward level. Record whether the diffuser was fitted when comparing your meter to Rosco’s chart.

Fit and setup

If you need a quiet fill below frame, use the small panel as the source for a bounce rather than asking the bare panel to cover the whole subject. In a dim interior, run the same check with your target colour to see where it falls on wardrobe and skin.

Alternatives and Related Fixtures

For a larger MIX soft panel, see Rosco DMG SL1 MIX.

Working in a tighter space? Compare the Rosco DMG DASH for smaller placements, or browse the Rosco / DMG fixture range for other panel sizes.

What People Are Saying

Field Feedback at a Glance

What worked

Drawbacks to plan for

  • The last step from minimum dimming to blackout was visible. Phil Rhodes, Definition.
  • The saturated blue R12 patch scored 74 in the 5,600 K test, lower than its overall color scores suggest. Phil Rhodes, Definition.
  • The kit uses separate power and control components, so there’s more to pack and connect than the head alone. Phil Rhodes, Definition.

Definition, MINI MIX review

Rhodes found the compact kit stacked neatly, but there are separate power and control parts to carry and connect. See his independent output readings above.

John Brawley, The Broadcast Bridge

Brawley describes using the MINI MIX alongside other DMG fixtures on The Resident. He highlighted the DMG family’s compact bodies, diffusion options and battery operation.

Jon Fauer, Film and Digital Times

In his MINI MIX hands-on article, Fauer found Bluetooth pairing straightforward and used Capture to choose a colour from a phone photo. He also noted that the MIX controller can sit on the fixture or run remotely on a longer cable.

Videos

Rosco’s IBC 2018 demonstration shows Nils de Montgrand sampling a colour from a photo in myMIX and sending it to a MINI MIX. This is an app demonstration, not an output test. Watch the MINI MIX Capture demonstration on YouTube.

Rental and Used-Fixture Checks

Confirm the driver, supply, head extension and chosen mount. A head-only listing leaves out components needed to power and control the fixture.

Before you book

Ask for the complete kit with matching driver, supply, head extension and desired front. Test the panel on the selected control path and confirm whether a battery plate is included if you plan to work untethered.

Documentation and Specifications

Back to contents · Browse all lighting equipment