Godox KNOWLED F200R

Last Updated 7 hours ago

Overview

Godox KNOWLED F200R emitting face on a stand with its separate controller
Godox KNOWLED F200R controller viewed from the side
ControllerF200R controller viewed from the side.
Godox KNOWLED F200R square mat with softbox and grid on a stand
Softbox and gridF200R square mat with softbox and grid on a stand.

The Godox KNOWLED F200R is the square 2 × 2 ft mat in the full-colour F series. It puts a two-foot source beside an interview subject without the depth of a COB and octabox. The similarly named F200SR uses a long 1 × 4 ft face. Both list 250 W input, but their shape, modifiers and output readings differ.

Detail photo

  • Fixture Type2 × 2 ft full-colour flexible LED mat.
  • Power Requirement250 W controller input; 100–240 V AC or supported 14.8 V or 26 V V-mount batteries.
  • Colour Temperature1,800–10,000 K Adjustable green/magenta tint.
  • Weight and Mount1.0 kg mat; 2.8 kg controller. Excludes frame and modifiers.
  • Beam ControlUse the softbox or grid to shape the light from the bare mat.
  • IP RatingIP54 Head and controller in the documented operating configuration, with connections protected as specified in the manual. IP Rating Guide.

Jump to Output Calculator ↓

Key specifications

SpecificationDetails
Format2 × 2 ft full-colour flexible LED mat
Bare mat size25.08 × 25.08 in
Bare mat / controller mass1.0 kg / 2.8 kg, excluding frame and modifiers
Controller input250 W
Power sources100–240 V AC, 50/60 Hz. 14.8 V or 26 V V-mount batteries.
White and tint1,800–10,000 K, adjustable green/magenta
Colour renderingAverage CRI ≥96, TLCI ≥98
Dimming0–100%, linear, S-curve, exponential and logarithmic
ControlOnboard, Bluetooth app, DMX512/RDM, CRMX
Ingress protectionIP54 head and controller in the documented operating configuration
Godox manufacturer specifications. Operating manual

Output Calculator

Select the published setup and a manufacturer distance, or enter a custom throw where supported. The results describe centre-beam output, not the brightness across the whole beam.

Camera Settings

If the calculator does not load, use the published photometric table or source on this page. JavaScript is required.

F-stop is a planning estimate, not a meter reading. It uses direct, on-axis illuminance and includes only the optics and diffusion named in the selected setup. Meter on set to account for lens transmission, filters, added diffusion, bounce, dimming and ambient light.

How the exposure estimate works

N = √(E × ISO × t / C), where E is illuminance in lux and t = shutter angle ÷ (360 × fps). The default C = 340 is a dome reference; C = 250 is a flat reference. These are calibration constants, not a measured T-stop. A small nonzero digit is tenths of a stop above the displayed full stop.

Distance estimates and comparisons

Published points are used as given. Between published points the calculator fits a curve through the two nearest readings. Outside those points it uses the inverse-square law only when the fixture’s dataset permits it. Distances outside a configuration’s supported range are reported separately. Comparisons use one shared distance and camera setup; equal lux does not imply equal coverage.

Square F200R or Strip F200SR?

Choose on reflection shape and clearance, not the small difference between their published bare centre readings. A square source gives a different catchlight and a different reflection on a glossy surface. The strip is the better starting point when one dimension of the rig has to stay narrow, and its modifiers are not interchangeable with the square F200R’s.

Strengths and limitations

Strengths

  • A square face gives similar coverage horizontally and vertically. That makes it easy to move from a seated interview to an overhead insert.
  • Two 14.8 V V-mount packs can reach the full dimmer setting, as can one suitable 26 V pack.

Limitations

  • One 14.8 V pack limits the available output. That matters if the interview has been exposed on mains and power changes between takes.
  • The square face makes a square reflection on glasses, screens and polished products. Its angle can matter as much as output.

Practical uses on set

SetupPlacement
Seated interviewSet the diffused mat above the interviewee’s eyeline. Check both eyes through the camera, especially when a subject wears glasses and turns toward the interviewer.
Tabletop overheadA square mat over a place setting gives the plate and glassware a broad highlight. Shift it off centre to put some shape back into the food.
Tight locationPlace the mat close to a wall and run its cable down to the controller. This keeps the key near the wall while leaving the controls reachable between takes.

Back to contents

Output and colour

Bare-mat output by distance

Colour temperature and mode1 m2 m3 m
5,600 K · Normal8,070 / 7502,280 / 2121,050 / 98
3,200 K · Normal6,900 / 6411,940 / 180895 / 83
5,600 K · High-speed8,900 / 8272,530 / 2351,180 / 110
Each cell gives lux / foot-candles. Lux readings are from Godox. Foot-candles are converted from lux and rounded.

Godox measures 2,280 lux at 2 m in Normal mode at 5,600 K. The F200SR gives 2,210 lux at the same distance and setting. Those centre readings are close. The square and strip-shaped reflections are visibly different on a glossy table or in a pair of glasses.

Back to contents

Power and batteries

Input is 250 W on 100–240 V AC. With a single 14.8 V V-mount on the left plate, the maximum displayed setting is 70% on the linear curve, 58.8% on S-curve, 87.2% on exponential and 39.2% on logarithmic. Godox lists full dimmer travel with two suitable 14.8 V packs or one 26 V pack. Those percentages describe the controller’s dimmer setting.

Control and camera operation

Patch DMX/RDM or link the built-in CRMX receiver for a console-controlled interview set. Bluetooth and the onboard controls are also available. Save the colour temperature, tint, intensity and dimmer curve together if the unit needs to be struck and rebuilt for a second interview day.

Godox publishes separate readings for Normal and High-speed modes. Test the selected mode, dimmer level and shutter on the production camera before shooting slow motion.

Modifiers, rigging and the working package

Order the square FS200 softbox for the K1 configuration or FA200 inflatable for K2. The F200SR takes different modifiers. Spread and seat all four arms of the F200R bracket before fitting the diffuser. Check the corners from camera when a clean, square reflection matters.

Fold the mat along its designated lines for transport. The IP54 rating applies to the head and controller with the connections protected as specified in the manual.

Back to contents

Alternatives and related fixtures

Compare sizes in the F series: Godox KNOWLED F100R (smaller 1 × 2 ft mat) or Godox KNOWLED F400R (larger 2 × 4 ft mat).

FixtureChoose it for
Godox F200SRSame nominal input and controller weight, with a 1 × 4 ft strip shape for long reflections and narrow spaces.
amaran F22cA square 2 × 2 ft colour mat to compare for battery, control and modifier compatibility.

What People Are Saying

Field Feedback at a Glance

These points concern the square full-colour F200R, not the slim F200SR. Sheldon’s review covers placement and source size; the battery and kit limits come from Godox.

What worked

Drawbacks to plan for

  • In Sheldon’s side-by-side comparison, the larger softbox changes the apparent size of the source and the look of the key. The square mat does not replace a larger emitting surface at the same distance.
  • With one 14.8 V pack, Godox’s manual lists a 70% maximum on the linear curve and 39.2% on the logarithmic curve. The manual lists 100% on those curves with two 14.8 V packs or one 26 V pack; check the packs and curve before a battery-dependent shoot.
  • The square F200R uses the FS200 softbox; the slim F200SR uses the FS200S. Godox’s manual separates the kits. Check the name on both the mat and modifier rather than booking a generic 200 W F-series kit.

Videos

Curren Sheldon demonstrates four placements for the F200R, including a documentary interview key.

Back to contents

Rental and used-fixture checks

  • Match the model name on the mat to the softbox and frame in the case. FS200S belongs to the slim F200SR. FS200 fits the square F200R.
  • Run a full-output test using the battery arrangement intended for the shoot. Check the low end again with the selected dimmer curve and the diffuser fitted.

Before You Book

Put F200R, not F200SR, on the order, and specify the matching square softbox or inflatable. Confirm which batteries are supplied and test your selected curve at the required exposure. Godox’s single-battery percentage is a controller limit, not a direct lux reading.

Documentation and specifications

Back to contents