Last Updated 7 hours ago
Overview



The Godox KNOWLED F400R is a 2 × 4 ft full-colour mat. Across a table it can key two seated people. Turned upright, its four-foot edge makes a long reflection for glass or polished metal. The bare mat weighs 1.8 kg and the controller another 5.8 kg, before batteries, frame or diffusion.
- Fixture Type2 × 4 ft full-colour flexible LED mat.
- Power Requirement460 W controller input; 100–240 V AC or supported 14.8 V or 26 V V-mount batteries.
- Colour Temperature1,800–10,000 K Adjustable green/magenta tint.
- Weight and Mount1.8 kg mat; 5.8 kg controller. Excludes frame and modifiers.
- Beam ControlUse the softbox or grid to shape the light from the bare mat.
- IP RatingIP54 Head and controller in the documented operating configuration, with connections protected as specified in the manual. IP Rating Guide.
Key specifications
| Specification | Details |
|---|---|
| Format | 2 × 4 ft full-colour flexible LED mat |
| Bare mat size | 25.08 × 48.07 in |
| Bare mat / controller mass | 1.8 kg / 5.8 kg, excluding frame and modifiers |
| Controller input | 460 W |
| Power sources | 100–240 V AC, 50/60 Hz. 14.8 V or 26 V V-mount batteries. |
| White and tint | 1,800–10,000 K, adjustable green/magenta |
| Colour rendering | Average CRI ≥96, TLCI ≥97 |
| Dimming | 0–100%, linear, S-curve, exponential and logarithmic |
| Control | Onboard, Bluetooth app, DMX512/RDM, CRMX, Ethernet (Art-Net and sACN) |
| Ingress protection | IP54 head and controller in the documented operating configuration |
Output Calculator
Select the published setup and a manufacturer distance, or enter a custom throw where supported. The results describe centre-beam output, not the brightness across the whole beam.
Camera Settings
If the calculator does not load, use the published photometric table or source on this page. JavaScript is required.
F-stop is a planning estimate, not a meter reading. It uses direct, on-axis illuminance and includes only the optics and diffusion named in the selected setup. Meter on set to account for lens transmission, filters, added diffusion, bounce, dimming and ambient light.
How the exposure estimate works
N = √(E × ISO × t / C), where E is illuminance in lux and t = shutter angle ÷ (360 × fps). The default C = 340 is a dome reference; C = 250 is a flat reference. These are calibration constants, not a measured T-stop. A small nonzero digit is tenths of a stop above the displayed full stop.
Distance estimates and comparisons
Published points are used as given. Between published points the calculator fits a curve through the two nearest readings. Outside those points it uses the inverse-square law only when the fixture’s dataset permits it. Distances outside a configuration’s supported range are reported separately. Comparisons use one shared distance and camera setup; equal lux does not imply equal coverage.
View published readings for the selected configuration
Where the F400R Fits
The 2 × 4 ft face gives more length along the line of the actors than the F200R’s square face. Orient the long axis for the reflection or coverage you need. If the rig must run along a low ceiling, compare the assembled softbox depth rather than assuming a flexible mat makes the whole assembly shallow.
Strengths and limitations
Strengths
- The four-foot edge gives a two-person setup more usable width while keeping the face only about two feet deep.
- The controller offers wired Ethernet, CRMX and two V-mount positions, making the same mat usable on a networked stage or a battery location.
Limitations
- Full output on batteries calls for two suitable 26 V packs. A pair of 14.8 V packs stops at 70% on the linear curve.
- The 5.8 kg controller and rigid bracket change the working package considerably. The 1.8 kg figure is only the bare mat.
Practical uses on set
| Setup | Placement |
|---|---|
| Two-shot at a table | Run the long edge parallel to the actors. Take a reading at both marks before fixing the stand position, particularly if one actor sits closer to the source. |
| Standing portrait | Turn the long edge vertically to carry a reflection or rim down a coat. A skirt on the wall side helps keep the background at its intended level. |
| Kitchen or counter | Run the long face along the work surface to create a continuous reflected edge. Rotate the mat while watching reflective appliances from the camera position. |
Output and colour
Bare-mat output by distance
| White point and mode | 1 m | 3 m | 5 m |
|---|---|---|---|
| 5,600 K · Normal | 13,300 / 1,236 | 1,900 / 177 | 768 / 71 |
| 3,200 K · Normal | 10,500 / 975 | 1,510 / 140 | 607 / 56 |
| 5,600 K · High-speed | 14,400 / 1,338 | 2,070 / 192 | 833 / 77 |
At 5,600 K in Normal mode the bare source measures 1,900 lux at 3 m and 768 lux at 5 m. These readings help set the working distance. For a two-person key, compare both actor marks after fitting the softbox and grid. A centre reading will miss a falloff difference between seats.
Power and batteries
The controller lists 460 W input on 100–240 V AC. On the linear curve, a single 14.8 V pack tops out at 40% and a single 26 V pack at 60%. A pair of 14.8 V packs reaches 70%, a mixed-voltage pair 90%, and a pair of 26 V packs 100%. A single battery goes on the left. Other curves have different displayed endpoints.
Control and camera operation
Alongside onboard control, Bluetooth, DMX/RDM and CRMX, the F400R accepts Art-Net or sACN through Ethernet. The controller offers DMX smoothing settings. Check a slow fade for visible steps, then check a sharp cue for lag before assigning the same setting to both.
Godox publishes separate readings for Normal and High-speed modes. Test the selected mode, dimmer level and shutter on the production camera before shooting slow motion.
Modifiers, rigging and the working package
The standard K1 configuration includes the FS400 softbox. K2 includes the inflatable FA400, its skirt, grid and pump. Each takes a different amount of room above an overhead frame. Check the head cable length with the stand at working height and the controller at its intended position.
Fold the mat along its designated lines for transport. The IP54 rating applies to the head and controller with the connections protected as specified in the manual.
Alternatives and related fixtures
Compare sizes in the F series: Godox KNOWLED F100R (smaller 1 × 2 ft mat) or Godox KNOWLED F200R (square 2 × 2 ft mat).
| Fixture | Choose it for |
|---|---|
| Aladdin MOSAIC 2×4 | A comparable rectangular colour mat when the package already includes Aladdin frames and dimmers. |
| Godox F200SR | A four-foot source approximately half as wide for strip highlights or narrow overhead positions. |
What People Are Saying
Field Feedback at a Glance
These points refer to the full-colour F400R. Crew observations and demonstrations are identified separately from the production manual.
What worked
- Gaffer Luke Seerveld describes the F400R as his go-to slim mat. His setup notes link a job with two F400Rs on menace arms, a concrete example of the rectangular full-colour mat on an existing rig.
- Andrew Lock’s modifier test compares bare, diffused, gridded and inflatable setups on the F400R. That gives a better basis for choosing a modifier than treating the bare output as what reaches the subject through diffusion.
- Godox’s production manual documents V-mount slots on the controller, including a left-slot-only option for a single pack. That makes a reduced-output setup possible on a job without nearby mains.
Drawbacks to plan for
- Dapper Gaffer’s build walkthrough shows the controller, head cable and inflatable accessory at assembly. The mat is thin, but it does not go up as a single self-contained light; allow prep time and a place for the controller.
- On the linear dimming curve, Godox’s production manual lists a 40% ceiling with one 14.8 V pack, 70% with two 14.8 V packs and 100% with two 26 V packs. The ceilings differ on other curves; test the actual packs and settings before relying on battery output.
- Gaffer & Gear’s separate wireless cue test compares smoothing enabled and disabled. Don’t infer cue timing from a static dimmer setting; check the actual fade and blackout with your console, wireless link and fixture settings.
Videos
Gaffer & Gear tests output, modifiers, dimming and CRMX on the F400R.
Dapper Gaffer builds the F400R and evaluates the working package.
Rental and used-fixture checks
- Lay out the bracket, correct rectangular diffuser, head lead and controller. Test the locking hardware at the orientation you expect to use.
- If the order calls for battery operation, verify pack voltage and run the intended level. If it calls for Ethernet, check the network input and run the actual console cues during prep.
Before You Book
Confirm the frame, head lead and either FS400 or the complete inflatable FA400 kit. For an overhead cue at a battery-only location, check the packs against the controller’s documented power limits and rehearse both the slow fade and a sharp cue.
Documentation and specifications
- Godox operating manual and photometric tables
- Godox KNOWLED full-colour F-series specifications
- Godox DMX mode chart
- Godox USA product photographs and kit information
Browse Godox lights · LED mats · all equipment.