Godox KNOWLED F100R

Last Updated 7 hours ago

Overview

Godox KNOWLED F100R rectangular LED mat on a stand with its controller
Godox KNOWLED F100R on a stand with the softbox and grid fitted
Softbox and gridF100R on a stand with the softbox and grid fitted.
Godox KNOWLED F100R controller and hanging loop
ControllerF100R controller and hanging loop.

The Godox KNOWLED F100R is a 1 × 2 ft full-colour LED mat for places where a softbox would put the stand too far into the room. Its narrow face can sit just outside a car window or run along the edge of a tabletop. The bare mat weighs 0.6 kg. The separate 2.8 kg controller accounts for much more of the package than the part you see in the shot.

Detail photo

  • Fixture Type1 × 2 ft full-colour flexible LED mat.
  • Power Requirement130 W controller input; 100–240 V AC or supported 14.8 V or 26 V V-mount batteries.
  • Colour Temperature1,800–10,000 K Adjustable green/magenta tint.
  • Weight and Mount0.6 kg mat; 2.8 kg controller. Excludes frame and modifiers.
  • Beam ControlUse the softbox or grid to shape the light from the bare mat.
  • IP RatingIP54 Head and controller in the documented operating configuration, with connections protected as specified in the manual. IP Rating Guide.

Jump to Output Calculator ↓

Key specifications

SpecificationDetails
Format1 × 2 ft full-colour flexible LED mat
Bare mat size13.54 × 25.04 in
Bare mat / controller mass0.6 kg / 2.8 kg, excluding frame and modifiers
Controller input130 W
Power sources100–240 V AC, 50/60 Hz. 14.8 V or 26 V V-mount batteries.
White and tint1,800–10,000 K, adjustable green/magenta
Colour renderingAverage CRI ≥96, TLCI ≥98
Dimming0–100%, linear, S-curve, exponential and logarithmic
ControlOnboard, Bluetooth app, DMX512/RDM, CRMX
Ingress protectionIP54 head and controller in the documented operating configuration
Godox manufacturer specifications. Operating manual

Output Calculator

Select the published setup and a manufacturer distance, or enter a custom throw where supported. The results describe centre-beam output, not the brightness across the whole beam.

Camera Settings

If the calculator does not load, use the published photometric table or source on this page. JavaScript is required.

F-stop is a planning estimate, not a meter reading. It uses direct, on-axis illuminance and includes only the optics and diffusion named in the selected setup. Meter on set to account for lens transmission, filters, added diffusion, bounce, dimming and ambient light.

How the exposure estimate works

N = √(E × ISO × t / C), where E is illuminance in lux and t = shutter angle ÷ (360 × fps). The default C = 340 is a dome reference; C = 250 is a flat reference. These are calibration constants, not a measured T-stop. A small nonzero digit is tenths of a stop above the displayed full stop.

Distance estimates and comparisons

Published points are used as given. Between published points the calculator fits a curve through the two nearest readings. Outside those points it uses the inverse-square law only when the fixture’s dataset permits it. Distances outside a configuration’s supported range are reported separately. Comparisons use one shared distance and camera setup; equal lux does not imply equal coverage.

Where the F100R Fits

Choose the 1 × 2 ft F100R when the mounted width matters more than the area of the source, for example along a windshield or above a narrow doorway. The F200R gives a square reflection instead. Compare with the modifier installed: the unbuilt mat width will not tell you whether a complete package clears a roof liner or door frame.

Strengths and limitations

Strengths

  • The 13.54 in short side fits beside door frames and under shelves. Turn the mat 90° to change the shape of a reflection.
  • Wired DMX and built-in CRMX keep dimming and colour accessible once the mat is tucked into the set.

Limitations

  • At 5,600 K the bare mat gives 454 lux at 3 m in Normal mode. A grid and diffusion reduce the light reaching the subject further.
  • The controller, cable and frame need their own space even when there is only room for the mat at the lighting position.

Practical uses on set

SetupPlacement
Car interiorWork through the side window of a parked picture car. Move the mat along the glass until its reflection clears the taking angle.
Countertop insertTurn the long edge parallel to a bottle or metal handle. Moving the mat changes where the reflected strip falls and how much of the product it describes.
Small room interviewPlace the diffused face close to the subject on the window side. Rotate the narrow edge toward the back wall when you want the key to spill less onto it.

Back to contents

Output and colour

Bare-mat output by distance

White point and mode1 m2 m3 m
5,600 K · Normal3,840 / 3571,020 / 95454 / 42
3,200 K · Normal3,310 / 308879 / 82392 / 36
5,600 K · High-speed4,740 / 4401,270 / 118585 / 54
Each cell gives lux / foot-candles. Lux readings are from Godox. Foot-candles are converted from lux and rounded.

At 2 m, switching from 5,600 K to 3,200 K in Normal mode takes the bare reading from 1,020 to 879 lux. With a tabletop or dashboard shot, meter where the face or object will actually sit. Moving a close mat a few inches can change both exposure and the reflected shape.

Back to contents

Power and batteries

The controller accepts 100–240 V AC at 50/60 Hz. For a battery setup, Godox specifies 14.8 V or 26 V V-mount packs and identifies the left slot for single-pack operation. The manual’s 70% ceiling with one 14.8 V pack is explicitly tabulated for the F200R and F200SR. Godox gives no equivalent ceiling for the F100R in that table.

Control and camera operation

Use the onboard controls for a single setup, Bluetooth from the Godox Light app for a mat hidden on set, or DMX/RDM and CRMX for cues. Match the dimming curve to the other fixtures if several lights need to fade out together. For an in-car effect, check the fade on camera at its lowest level.

Godox publishes separate readings for Normal and High-speed modes. Test the selected mode, dimmer level and shutter on the production camera before shooting slow motion.

Modifiers, rigging and the working package

The K1 package uses the FS100 softbox with a diffuser and grid. The K2 uses the FA100 inflatable softbox. Account for the assembled depth before committing to a visor-height position. The bare mat dimensions only describe the emitting assembly. Route the head lead so opening a door does not pull on the mat.

Fold the mat along its designated lines for transport. The IP54 rating applies to the head and controller with the connections protected as specified in the manual.

Back to contents

Alternatives and related fixtures

Compare sizes in the F series: Godox KNOWLED F200R (square 2 × 2 ft mat) or Godox KNOWLED F400R (larger 2 × 4 ft mat).

FixtureChoose it for
amaran F21cA second 2 × 1 ft colour mat to compare when you already carry amaran control gear or modifiers.
Godox F200SRA longer 1 × 4 ft face for a continuous reflection across a wider object.

What People Are Saying

Field Feedback at a Glance

These points concern the full-colour KNOWLED F100R. The model-specific details come from Godox’s production manual; the cited dealer walkthrough is a family overview, not independent F100R testing.

What worked

  • At about 0.6 kg (1.3 lb) for the bare 1 × 2 ft mat, the F100R keeps the weight of the emitting surface low. Luke Rollins’s F-series overview for B&H identifies vehicle interiors and low ceilings as uses for the folding family; that article does not give an F100R-specific setup or output test.
  • The F100R’s wired DMX/RDM, LumenRadio CRMX and Bluetooth app control are documented in Godox’s manual. On a cramped set, that lets you set level and colour without needing a hand at the mat.
  • The F100R accepts a separately supplied 14.8 V or 26 V V-mount pack; Godox’s manual specifies the left slot if using one battery. That lets you prep a portable fill without running mains to the controller.

Drawbacks to plan for

  • The 0.6 kg figure is only the mat. Godox’s manual lists the controller at roughly 2.8 kg (6.2 lb), before the battery, head cable or modifier. Plan where each part will sit before raising the light.
  • The separately available Air Softbox attaches at the perimeter, as shown in Luke Rollins’s F-series overview for B&H. It adds depth to a flat mat, so check actual clearance in the vehicle or ceiling pocket with the modifier fitted.
  • The F100R mat and controller are IP54 per Godox’s manual; do not treat them as waterproof or leave ports and mains connections exposed. This is a rating of the listed parts, not a field water test.

Videos

Godox’s F-series demonstration shows how the mats and modifiers fit together. It covers all five sizes.

Back to contents

Rental and used-fixture checks

  • Inspect the emitting face at low white, then in red, green and blue. A dark segment is easier to see before the diffuser goes on.
  • Fit the bracket to all four mounting points and check the head lead, controller mount and left battery plate. Set up the actual modifier to check clearance before taking it into a small location.

Before You Book

Ask whether the rental includes the FS100 softbox or the FA100 inflatable and its pump. If the controller must run off one battery, confirm the actual F100R pack, connection and available output rather than borrowing the F200R’s published battery limit. Check the camera at the bottom of a programmed fade before putting the mat in a hard-to-reach position.

Documentation and specifications

Back to contents