Last Updated 7 hours ago
Overview
The Godox KNOWLED F800R is a full-colour 4 × 4 ft LED mat for a broad overhead, a large near-camera fill or a window-sized key. Its face folds for transport and opens to just over four feet square. Allow space on set for the frame and modifier, plus a separate 6.5 kg controller.
- Fixture Type4 × 4 ft full-colour flexible LED mat.
- Power Requirement900 W maximum controller input; 100–240 V AC or compatible external 48 V DC.
- Colour Temperature1,800–10,000 K Adjustable green/magenta tint.
- Weight and Mount3.0 kg bare mat; 6.5 kg controller. Excludes frame and modifiers.
- Beam ControlShape the bare mat with the FS800 softbox or the FA800 inflatable softbox kit with grid.
- IP RatingIP54 Light body and controller in the documented operating configuration. IP Rating Guide.
Key specifications
| Specification | Details |
|---|---|
| Format | 4 × 4 ft full-colour flexible LED mat |
| Bare mat size | 48.07 × 48.07 in |
| Bare mat / controller mass | 3.0 kg / 6.5 kg, excluding frame and modifiers |
| Controller input | 900 W maximum |
| Power sources | 100–240 V AC, 50/60 Hz. Compatible external 48 V DC supply. |
| White and tint | 1,800–10,000 K, adjustable green/magenta |
| Colour rendering | Average CRI ≥96, TLCI ≥97 |
| Dimming | 0–100%, linear, S-curve, exponential and logarithmic |
| Control | Onboard, Bluetooth app, DMX512/RDM, CRMX, Ethernet (Art-Net and sACN) |
| Ingress protection | IP54 head and controller in the documented operating configuration |
Output Calculator
Select the published setup and a manufacturer distance, or enter a custom throw where supported. The results describe centre-beam output, not the brightness across the whole beam.
Camera Settings
If the calculator does not load, use the published photometric table or source on this page. JavaScript is required.
F-stop is a planning estimate, not a meter reading. It uses direct, on-axis illuminance and includes only the optics and diffusion named in the selected setup. Meter on set to account for lens transmission, filters, added diffusion, bounce, dimming and ambient light.
How the exposure estimate works
N = √(E × ISO × t / C), where E is illuminance in lux and t = shutter angle ÷ (360 × fps). The default C = 340 is a dome reference; C = 250 is a flat reference. These are calibration constants, not a measured T-stop. A small nonzero digit is tenths of a stop above the displayed full stop.
Distance estimates and comparisons
Published points are used as given. Between published points the calculator fits a curve through the two nearest readings. Outside those points it uses the inverse-square law only when the fixture’s dataset permits it. Distances outside a configuration’s supported range are reported separately. Comparisons use one shared distance and camera setup; equal lux does not imply equal coverage.
View published readings for the selected configuration
Where the F800R Fits
The F800R gives a square four-foot source for large reflections or several marks under one key. If there is room for width but not depth in plan, compare the rectangular F400R before ordering. If the F800R is close to the work, meter the actual edges and centre after diffusion instead of assuming the centre number describes the full working area.
Strengths and limitations
Strengths
- A single square face can make one broad reflection in a car panel or tabletop and can cover movement around a table.
- Ethernet and CRMX keep intensity, tint and colour accessible when the frame sits above the set.
Limitations
- There are no V-mount plates on the controller. Location DC requires a compatible external supply.
- The mat is 48.07 in wide before the frame and hardware. A nominal four-foot opening offers no spare room to install the complete unit.
Practical uses on set
| Setup | Placement |
|---|---|
| Dining-table overhead | Centre the source over the playing area and take readings at the seated and standing marks. Skirt the sides that throw light onto the walls or into the lens. |
| Window key | Place the square mat outside the camera’s view of the window. Check the glass from every camera position for a reflected frame, particularly on night interiors. |
| Automotive or product reflection | Move the whole square while watching the highlight across the curved surface. A slight change of angle can move the seam or bright edge away from a badge without changing intensity. |
Output and colour
Bare-mat output by distance
| White point and mode | 1 m | 3 m | 5 m |
|---|---|---|---|
| 5,600 K · Normal | 23,700 / 2,202 | 3,850 / 358 | 1,510 / 140 |
| 3,200 K · Normal | 19,800 / 1,839 | 3,230 / 300 | 1,260 / 117 |
| 5,600 K · High-speed | 24,200 / 2,248 | 3,970 / 369 | 1,560 / 145 |
At 3 m the bare light measures 3,850 lux at 5,600 K in Normal mode. At 5 m it measures 1,510 lux. With a four-foot emitting face, very close placements change the way different parts of the source contribute to the reading. For a large tabletop or group, meter at the edges of the working area as well as the centre.
Power and batteries
Godox rates the controller at a maximum 900 W input on 100–240 V AC. The F800R also accepts a compatible external 48 V DC supply. The manual specifies the DC driver requirements. Confirm the supply, mating cable and available output as a package with the rental house before a battery-only call.
Control and camera operation
The F800R supports wired DMX/RDM, built-in CRMX, Bluetooth and Ethernet using Art-Net or sACN. For a standing set, agree on the universe, address and behaviour on signal loss before the overhead goes up. Rehearse the warm-to-cool cue on camera if the actors move between this mat and practical lamps.
Godox publishes separate readings for Normal and High-speed modes. Test the selected mode, dimmer level and shutter on the production camera before shooting slow motion.
Modifiers, rigging and the working package
The F800R frame opens into a full square. Check clearance for the frame, tilt hardware and cable exit before positioning it over scenery. The K1 package uses the FS800 softbox. K2 uses the inflatable FA800 with a grid, skirt and pump. The bare mat is 3 kg. The complete overhead load also includes the frame, modifier, attachment hardware and supported cable.
Fold the mat along its designated lines for transport. The IP54 rating applies to the head and controller with the connections protected as specified in the manual.
Alternatives and related fixtures
For a smaller mat in the same series, compare the Godox KNOWLED F400R (2 × 4 ft) or the Godox KNOWLED F200R (2 × 2 ft).
| Fixture | Choose it for |
|---|---|
| Aladdin MOSAIC 4×4 PIXEL | A square mat for cues that need independently controlled regions across the face. |
| Aladdin MOSAIC 2×4 | A narrower rectangular face for locations where a four-foot square and its frame occupy too much width. |
What People Are Saying
Field Feedback at a Glance
These points refer to the full-colour F800R. Crew observations and demonstrations are identified separately from the production manual.
What worked
- Gaffer Luke Seerveld uses the large, lightweight F800R as a working fixture. His Santa Fe print example shows the mat used through patterned diffusion; he reports having enough output to soften the source further. That’s a set example, not a lux test.
- Erik Naso’s NAB first look shows the 4 × 4 ft folding frame, ball-bungee fixings and hook-and-loop perimeter for the diffuser or grid. Use it to see how the frame goes together, not as a source for the shipping fixture’s ratings.
- Godox’s production manual documents a conventional softbox package and an inflatable option. The two give you different ways to add depth in front of the mat; specify the modifier you actually need when booking.
Drawbacks to plan for
- The F800R does not have the F400R’s V-mount slots. Godox’s production manual calls for a suitable certified external driver with no more than 48 V DC at the DC input. Do not count on clipping a V-mount battery onto the controller.
- The production mat and controller are rated IP54 in Godox’s production manual, not the IP65 quoted in early NAB coverage. Keep unused ports capped and protect the mains connection separately.
- The mat’s low weight does not account for its large frame, modifier or head cable. Erik Naso’s NAB first look shows the actual frame span; allow room to assemble and square it, then plan support for the complete package.
Videos
Newsshooter’s NAB floor demonstration shows the F800R frame and modifier attachment.
Rental and used-fixture checks
- Open and square up the frame, check the joints and tensioners, then fit the ordered diffuser. Inspect the head cable strain relief and all four corners before raising the unit.
- For the inflatable kit, check the pump and observe whether the modifier holds its shape. For external DC, test the supplied cable and power source at the color temperature and dimmer level you plan to use.
Before You Book
Confirm the complete supported load and clearance with the frame, modifier, tilt hardware and cable in place. Specify whether you need the FS800 or the FA800 package and, for DC, have the rental house confirm the compatible 48 V source and mating cable as a tested pair.
Documentation and specifications
- Godox operating manual and photometric tables
- Godox KNOWLED full-colour F-series specifications
- Godox DMX mode chart
- Godox USA product photographs and kit information
Browse Godox lights · LED mats · all equipment.

